Table of Contents
Advertisement
User's Manual
WARNING
Failure to follow instructions may
cause damage or explosion,
always shield eyes. Read entire
instruction manual before use.
R
Warning: This product contains chemicals,
including lead, known to the State of
California to cause cancer, birth defects
and other reproductive harm.
Wash hands after handling.
Advertisement
Table of Contents
Related Manuals for Booster ES5000
Summary of Contents for Booster ES5000
- Page 1 User’s Manual WARNING Warning: This product contains chemicals, including lead, known to the State of Failure to follow instructions may California to cause cancer, birth defects cause damage or explosion, and other reproductive harm. always shield eyes. Read entire Wash hands after handling. instruction manual before use.
-
Page 2: Safety Summary
Read and follow all safety instructions published in the vehicle's Owner's Manual. While the battery in the Booster PAC is a sealed unit with no free liquid acid, batteries being jump started with the Booster PAC unit likely contain liquid acids which are... -
Page 3: Personal Precautions
Do not operate with flammables such as gasoline, etc. If the Booster PAC receives a sharp blow or is otherwise damaged in any way, have it checked by a qualified service person. If the Booster PAC is leaking battery acid, do not ship it. -
Page 4: Recharging
With this method, the wall charger is connected to the Booster PAC through a small charging jack (pin jack), located on the rear of the unit. Recharging takes approximately 4 to 6 hours for each light that does not come on when the test button is pressed. - Page 5 To assess the unit’s readiness, monitor the Power Level LED’s. 5. If you are not planning to use your Booster PAC right away, you may leave it connected to the wall charger. We recommend that the wall charger remain connected to the Booster PAC when not in use.
-
Page 6: Used As Emergency Jump Starter
PAC to the 12 Volt outlet on the vehicle, the memories can be saved. Note: To use the Booster PAC for this purpose, the chosen outlet must be live when the vehicle is turned OFF. On some vehicles, 12 Volt outlets are deactivated when the vehicle is turned OFF. -
Page 7: Troubleshooting
Problem: The Booster PAC is fully charged but has no power. Answer: Check where the wire meets the jaw on the Booster PAC clamp. Make sure they are well crimped. Problem: When trying to use an accessory through the 12 Volt outlet on the Booster PAC, I heard a clicking sound coming from inside the Booster PAC. - Page 8 TEST button. If all power indicator lights come on, it is fully charged. Question: How can I test the battery in my Booster PAC to see if it needs to be replaced? Answer: We recommend that you use a 100 amp battery load tester. Load the Booster PAC battery for 6 seconds with a 100 amp load and it should maintain at least 9 Vdc.
-
Page 9: Testing The Battery
Begin by making sure that both clamps are securely stowed in their holsters on each side of the Booster PAC. 1. Lay the Booster PAC down on its front. On the back of the unit, locate the four screws that hold the case together (two along the left edge and two along the right edge). -
Page 10: Warranty
For best service and to receive periodic product updates, follow the instructions below to register your purchase: Please visit: www.cloreregistration.com Click on the Booster PAC logo Complete the information in the web form and click “submit” It’s that easy! For answers to questions concerning use, out-of-warranty service, or warranty/service... - Page 11 User’s Manual Clore Automotive • Kansas City, MO 64161 • www.cloreautomotive.com • 913.310.1050 Warning: This product contains chemicals, including lead, known to the State of California to cause cancer, birth defects and other reproductive harm. Wash hands after handling. © 2006 Clore Automotive, 6/06 842-270-020...