Hello all,
I am kind of newbee on how to setup CAN on ardupilot so I wanted to ask if I am doing anything wrong.
I do have a Mateksys L431 adapter where I am trying to see as a CAN Node on SLCAN monitor. I have followed up the documentation yet I was unable to update the firmware of Mateksys to begin with. Later on I have managed to do the SLCAN parameters and tried to connect from DroneCAN/UAVCan page on MP and it did connect but I dont see the Mateksys as a node on the list.
I have downloaded Dronecan GUI as well as I have not manage to make that work too.
I am probably doing something wrong yet not sure what it is.
What steps I should be following?
Thanks a lot.
Tolga