This document applies to HP Pavilion 14-v000 notebook computers.
Removing and Replacing the Battery for HP Pavilion 14-v000 Notebook PCs
Before you begin
-
Turn off the computer. Disconnect the Ethernet or modem cable. Disconnect the power cord.
-
Transfer the computer to a clear, flat, stable work surface over a non-carpeted floor.
-
HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the computer.
-
Do not remove a component from its protective packaging until you are ready to install it.
warning:Before starting, power off the computer and wait for components to cool before starting these procedures.
caution:This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a non-carpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.
caution:Procedures in this document are provided by HP for qualified service agents and as a courtesy to its customers. Servicing internal components increases the risk of damaging the computer which might not be covered under warranty. Understand the risk and refer to the product's warranty before attempting to service the computer.
Video overview
View the following video before using the steps in this article.
Removing and Replacing the Battery for HP Pavilion 14-v000 Notebook PCs
Learn how to remove and replace the battery for HP Pavilion 14-v000 Notebook PCs.
note:The video and graphics in this article depict a specific configuration of notebook computer. These same removal and replacement procedures apply to all configurations for all HP Pavilion 14-v000 notebook computers.
Removing the battery
Follow the steps in this section to remove the battery.
warning:Make sure the computer is disconnected from power before starting.
|
Step 1
Slide the battery lock latch to the unlock position (identified with an “unlock” icon).
|
|
|
Step 2
Slide the battery release latch (identified with a battery icon) into the release position to partially eject the battery.
|
|
|
Step 3
Lift the front edge of the battery and remove the battery from the battery bay.
|
|
Replacing the battery
Use the steps in this section to replace the battery.
|
Step 1
Insert the rear edge of the battery into the battery bay and lower the battery until it is properly seated and the battery release latch clicks.
|
|
|
Step 2
Slide the battery lock to the lock position to secure the battery.
|
|
Enter a topic to search our knowledge library
What can we help you with?
Need Help?